Pixsys ATR264-12ABC-T process controller with NFC programming, 15 cycles / 30 steps
ATR264 is a programmer dedicated to the automation of small industrial ovens or laboratory ovens, dryers, heat treatment systems, and in general the management of a process involving cycles/profiles with control of the process variable in relation to time.
ATR264 allows the programming of 15 cycles/profiles, each one including up to 30 steps/segments, all free configurable by the user as ramp/soak/cooling.
The device integrates software functions typically required in oven/furnace management: Waiting (in the case the process is delayed in comparison to programmed setpoint) and Cycle Recovery mode (after any power failure). Special function for gas kilns management are available (code -13ABC).
Like other Pixsys programmers, ATR264 stands out for user-friendly interface and programming mode even for inexperienced operators.
Parameter configuration and cycle programming is possible via MyPixsys App on smartphone thanks to NFC/Rfid technology or on PC with MyPixsysLab software as well as directly from keyboard.
| Power supply | 24-230 Vstř/ss |
| Design (panel size) | 48 x 48 mm |
| Type of regulation | ON/OFF,PID |
| Control input | Universal |
| Auxiliary digital input | Yes |
| Output - relay | 2x |
| Output for SSR | 2x |
| Analog output | Yes |
| Display digit colour | Two colours |
| Producer | Pixsys |
- 15 cycles of 30 steps can be set
- On-Off, P, PI, PD time proportional, PID control, double PID
- Universal analog input configurable software: Thermocouples K, S, R, J, T, E, N, B, Pt100, PT500, Pt1000, Ni100, PTC, NTC, analog 0-1 V / 0-5 V / 0-10 V / 0-20 mA, 4-20 mA, 0-60 mV
- 2x auxiliary digital input with programmable function
- 2x output relay + 2x output for SSR + Analog output V/mA
- CT input for detection of control loop failure
- Wide power supply range 24..230 Vac/dc
- RS485
This online store saves cookies that help its proper functioning. By using our services, you agree to their use.